AI Traffic sinking into ground

[hagar]

First of all I will thank the team for a "yaw dropping" scenery, it really did overrun my expectations, with respect to details and quality.

I've been following this forum the last weeks hoping for someone to post a similar problem that I have been trying to resolve after the release of version 3.0. Apparently not, I hope eventhough that some of you may have a possible solution to the problem.
When running the new Featurepanel and switching on most of the relevant NL2000 features under Scenery and Misc. all of my AI traffic are plowing 6 feet into tarmacs, taxiways and runways. In the 2.9 version this was possible to fix by choice, in the 2.9 featurepanel. It seems like this is "fixed" once and for all in ver. 3.0 since it is not a choice anymore.

I've spent some hours testing with and with most of the choices, under Scenery and Misc. without being able to isolate the problem. When I swich off all choices in the featurepanel, AI traffic is moving normaly and at ground level. As soon as I swich on f. ex. FS2004 navaids, flattened water etc. they sink into the ground. Note that this is only valid for AI traffic, aircraft of choice, acts normally independent of changes done in the Featurepanel.
All of my AI traffic is installed manually and is behaving normally outside the Netherlands.

Any clue, anyone ?

regards
Per Krogh

[wolf32]

Is there version 2.9 still activated in your scenery library of FS2004 (or perhaps another older version).
Than you have to de-activate it in your scenery library of FS2004.
Hope this will solve your problem.

[hagar]

You were right, it was an older version running in background, overseen in the scenery list in fs9, now everthing runs perfectly, fps jumped from 10-12 to + 25.

Thanks a lot

P. Krogh