Disappearing Buildings

deltafan · Post by **deltafan** » Wed May 11, 2005 2:53 pm

OK, I just got 2.91 and SP2. I entered the flatten commands manually as stated in the first parts of the manual, at at EHAM, I still get disappearing buildings and aprons. Any help?

Javier_Tapia · Post by **Javier_Tapia** » Sat May 14, 2005 6:39 am

I have fs2002 and the buildings in EHAM and an other airport I don't remember know, even with the flattern for FS9, continue to dissapear... What could it be

rsmt · Post by **rsmt** » Sat May 14, 2005 9:19 am

I've checked the Dutch part of the forum and there is an old tread on this subject.

The tread stopped after the advice, with successful feed-back, to update the video driver with the latest version.

I hope this helps!
Ron.

deltafan · Post by **deltafan** » Sat May 14, 2005 2:12 pm

Well I'm using an ATI Radeon 9200 using OMEGA drivers, which I don't want to dump because with out them, I have texture display problems with my airplanes. Does it say that 3rd party drivers are compatible?

rsmt · Post by **rsmt** » Sat May 14, 2005 5:37 pm

It says:

Nu net de nieuwste ATI drivers van donderdag de 14de oktober geinstalleerd en geen probelemen meer!

which translates into: "Just installed the latest ATI drivers of Thursday October 14th (2004 rsmt) and no problems anymore!"

Regards,
Ron.

deltafan · Post by **deltafan** » Sat May 14, 2005 6:59 pm

Well, my OMEGA drivers are dated newer than that I believe, and like I said, I don't want to go to standard ATI drivers because some of my planes will have texture display problems, for some, unknown reason (computers are weird). Nevertheless, I will see if there are newer dated OMEGAs and see if they help. I'll notify back when I get a chance. Thanks.

deltafan · Post by **deltafan** » Sun May 15, 2005 12:55 am

Sadly, the new drivers didn't help. Any other suggestions?

rsmt · Post by **rsmt** » Sun May 15, 2005 9:08 am

I've checked the Dutch section again and found that in early 2004, so for v 2.91, a change to "landable water" in the feature panel also helped. Disadvantage was some reduction in frame rates, but Schiphol was at least visible and without disappearing buildings.

I suggest to try this also.

Good luck! Unfortunately I can't help you further because of lack of skills and knowledge.

Regards,
Ron.

deltafan · Post by **deltafan** » Sun May 15, 2005 2:08 pm

It says landable water requires a 2.6GHz processor, I only have a 1.5GHz (I'm behind, LOL). Will it still work?

Javier_Tapia · Post by **Javier_Tapia** » Fri May 27, 2005 2:58 am

I got landable water on.. still dissapearing the buildings

Disappearing Buildings

Disappearing Buildings

drivers

Who is online

Feed

Go to page