EBBR- Brussels National

[dschaum]

With The Netherlands 2000 scenery activated, EBBR has trees all over the taxiways and the aircraft parking ramps.

I have had one other person confirm this is happening to him as well.

Could someone take at look at what might be causing this.

I'm running FS2004, seamless textures.

Thanks,

David Schaum

[Stefan]

yes I can confirm that, the same problem here, I went for a Flight in my 737 from EBBR and when I loaded the Airport there where threes and houses all over the ramp, taxiways etc etc.

[lcs]

I think there is something wrong with youre Settings i have tried everything but there are no Threes and houses at the Ramp and at the RWY's at EBBR everythings working good here with the NL2000 installed, when you go to airport, thirst have look if you are in the Netherlands, if so go to Belgium and then choose EBBR i think thats the problem.

Regards:
Leen
Delft
The Netherlands

[Rien_Cornelissen]

Hello to all,

I tried and found that David is right. Normally I have autogen set to zero for nl2000, but after activating it I can see trees on the platform and some taxiways at EBBR. After switching off nl2000 in the scenery library the trees are gone.

Therefore, I can confirm David's remark but I don't have a solution apart from switching off autogen when using nl2000 and flying in its area. In nl2000 it is of no use anyway.

Best regards,

Rien Cornelissen.

[Considero]

I have the same problem. It occurs in all 4 models in NL2000 version 2.91 The problem is not just on EBBR but on all the airfields in Belgium and Germany near the Dutch border. So I assume that FS2004 does not recognise the airfield aera's near the border as such.

By the way. Thanks for the great scenery you give us Flightsimmers for free. I hope you still enjoy the project. Don't let disturb your mood by some spoiled people who made a hobby of nagging. Keep smiling. A lot of people are very pleased with the job you did.

Greetings,
Arjen