Problem with textures

ideoplastic · Post by **ideoplastic** » Sat Mar 08, 2008 4:56 pm

I've just rebullt FS9 and loaded a fresh NL2003 V3, the problem I'm having
is that I'm getting a checker board texture effect between default FS9 textures and NL2003 one. Did get this on my last install. Any advice/help much appreciated.

Thanks and regards

Joaquin

pnauta · Post by **pnauta** » Sat Mar 08, 2008 5:42 pm

Did you run the Feature Panel after installation?

johanc · Post by **johanc** » Sat Mar 08, 2008 7:52 pm

Hi,

There are two things you can also check:

- Is the Europe west scenery activated (if not, you see checker board textures near the coast): active it
- If you only see checker board texture effects on the boarders of the netherlands (belgoim/Germany), then you can do nothing about it. At those places, the fotosceneery ends and the MS default scenery is shown. Because the 1 m/p photoscenery is at the top it can not blend and you see sharpe square shaped photo textures.

Problem with textures

Problem with textures

Who is online

Feed

Go to page