www.nl-2000.com

Hi all am new to here love what you are doing. My problem is i have up dated but when I am at EHAM the alt is set at 10 not 0 when I ask for line for taxing I can't see it any sugestions. I have checked in the file for sceanery and the stuff is all there. Help!

What kind of plane are you using? If you use a big jet the altitude that FS displays can actually be 10, because it is the altitude of the reference point of the plane above the ground (which is at 0 ft in our scenery). So that doesn't have to be a problem at all.

And about the taxi instructions. I assume you refer to the Fs2002 progressive instructions that show on the taxiways? I'll check this, but it can be that they are covered by our ground polygons, as they are displayed at a certain layer.

Hello,

I had the same problem but i have changed in AFCAD the reference point to 0 and the progressive taxi line appeard again.

Greets, Jip

P.S. My English is very bad so i hope you know what i mean.

Yes I was refering to the progressive instructions sorry but lousy at spelling so I used what I used. And to Jip de Kort thanks that fixed my problem I under stand what you were saying just fine. Thats it all fixed. In the AFCAD alt. was set to -2.38 so every thing was under ground thanks all for your help.

During nighttime whilst taxiing in anything from an A320 to a F100, when you come off the rwy and onto the taxiways, all the lights disappear on the ground.

Also 24/7 when you come off the rwy you hit a bump and seem to drop down - that is when the light problem happens.

Looks like a flatten problem (refering to the bump), can you check if you have the flatten switches installed properly (they are mentioned in the manual).

Ok sorry guys; didnt read the bit on the feature panel. Now works fine.

Nice scenery. Well done!