Dear designer team !
Congratulation to your very good scenery !
After reinstalling FS9 and Netherland 2000v3sp I have the problem (only at EHAM), that the wheels of my aircrafts, as soon as leaving the apron are sinking into the ground, dust is raising arround as if it is rolling over an open field. For some aircrafts (heavy) you can´t even taxi after a stop even with full power - and also not make a takeoff.
I have the same scenerys as before reinstallation - UTE, GE, ............ and (new) Global 2010
Dou you have any solution ?
Cheers
Franz
EHAM
Moderator: NL2000 Development Team
Hallo Joop !
Thanks for your answer !
Maby I´m to old or stupid, but I can´t find the AFCAD in the feature Panel ????
At the NL2000 EHAM butto I find - Use NL2000 EHAM White road markings, red safety lines, white tow lines, ......
but don´t find the AFCADs
On which page can I read it in the manual ?
Cheers
Franz
Thanks for your answer !
Maby I´m to old or stupid, but I can´t find the AFCAD in the feature Panel ????
At the NL2000 EHAM butto I find - Use NL2000 EHAM White road markings, red safety lines, white tow lines, ......
but don´t find the AFCADs
On which page can I read it in the manual ?
Cheers
Franz
Franz,
OK, so that is allright.
And version3 or version 3SE is the same for hat the airports are concerned. Only a different photoground scenery.
I read, that you also have UTE en Global.
Do you have the NL2000 items in the library a higher priority
then UTE and Global ?
When you disable ( not uninstall ) this items in the library , do you still have the same problem?
Joop
NL2000team
OK, so that is allright.
And version3 or version 3SE is the same for hat the airports are concerned. Only a different photoground scenery.
I read, that you also have UTE en Global.
Do you have the NL2000 items in the library a higher priority
then UTE and Global ?
When you disable ( not uninstall ) this items in the library , do you still have the same problem?
Joop
NL2000team
Who is online
Users browsing this forum: No registered users and 2 guests